KBS Coatings DiamondFinish Clear Coat

Diamondfinish Clear Is A Tough Clear Coat That Can Be Applied Direct To Metal Or Over Other Coatings. This Water Clear High Gloss Clear Coat Remains Permanently Flexible And Is Able To Perform In The Toughest Environments Without Yellowing, Cracking Or Peeling.

Make sure this fits by entering your model number.
DiamondFinish Clear is Formulated to Apply Directly Over Other Coatings or Direct To Metal DTM. DiamondFinish Clear is a permanent high solids over 60% and low VOC’s Clear Coat
DiamondFinish Clear is a Moisture Cured Urethane which is an advanced coatings technology offering durability, flexibility, corrosion and chemical resistance. DiamondFinish Clear can be applied directly to Painted Surfaces with Minimal Surface Prep. DiamondFinish Clear is incredibly tough and hard like no other clear coat on the market
DiamondFinish Clear is a water clear high gloss clear coat remains permanently flexible and can perform in the toughest environments without yellowing, cracking or peeling. DiamondFinish Clear can be applied with a brush without leaving any brush marks, roller and conventional spray gun
With DiamondFinish Clear, unlike normal two-part coatings, no hardener is needed. You can just stir and go. DiamondFinish Clear will cure without heat or UV lights in temperatures from 50° to 86° Fahrenheit. DiamondFinish Clear can be applied directly to a cured Automotive basecoat, Standard solid color paints, and Single Part or Two-Part paints. DiamondFinish Clear can also be applied to Non Ferrous metals including Aluminum, Alloys, Brass, Chrome and Copper
DiamondFinish Clear withstands the harshest of chemicals including fuels, solvents, Battery acid, Brake fluid, Ethanol, Methanol, MEK, Hydrochloric Acid, Fertilizers, and Acetone. DiamondFinish Clear is Graffiti Resistant: because of its chemical resistance, grafitti just won’t stick and can be removed simply with a solvent soaked rag
DiamondFinish Clear is Great for high temperature automotive applications including the use on cylinder heads, engine blocks, brake components and even inlet manifolds, without yellowing up to 300° Fahrenheit
When needed, DiamondFinish Clear can be cut and polished/buffed to remove any imperfections, runs, brush marks, etc. after 24 hours under normal environmental conditions. You will cut and buff/polish DiamondFinish Clear the same way you would an automotive clear coat.